MONTERO Gen3 - Front Strut Top Hat Spacers, 6mm, 1 Pair

Size: 6mm (.22") thick spacer results in 10-12mm (.4-.5") of lift

Although we don't recommend large spacer lifts because they will change the geometry of the suspension arc and can cause the upper control arm to hit the shock absorber at full droop, these thin aluminum top hat spacers are perfect for adding a little bit of height to fine-tune your suspension set-up. Unlike a preload spacer or spring perch adjustment, this top hat spacer will not affect the shock/spring dynamics. Very easy to install since the struts do not need to be disassembled.

A wheel alignment is required after installation.

Common Uses:

• Leveling out the suspension front to back
• Extra clearance
• Gaining some height back after adding heavy accessories that caused the front end to sag down 
• Leveling out the suspension left to right (The left side often rides lower than the right side because of the battery, brake booster, and driver's weight. Remove the front sway bar and measure the ride height of both the left and right wheels to check for this.)
• Trading uptravel for downtravel in the suspension arc.

NOTE - Alternatively, if you would rather use these as a preload spacer, the holes can be drilled out to 11/16 (17mm) and then these spacers will fit under the strut top hat (see photo).