MONTERO Gen1 & Early Gen2 - HD Torsion Bars (1278mm)

(No reviews yet) Write a Review
$329.95
SKU:
VS-LVL-MITS013

Product Overview

Fitment:

1983-1991* Montero Gen1 2.6L I4, 3.0L V6

 

Sold in Pairs

Lovells heavy duty Torsion Bars are available as an upgrade to enhance the load carrying ability of vehicles which have independent front ends (torsion bar front). Lovells torsion bars are manufactured from larger diameter bar than original equipment which will increase spring rate and maintain ride height when the vehicle is fitted with constant added weight over the front such as a steel bumper, winch, skids plates, etc. Lovells Torsion bars feature ‘upset’ forged ends which increase strength by improving the steel structure and rolled splines.

Length: 1278mm - *Always measure your existing torsion bars to confirm length prior to ordering. *Some early Gen2s also used these shorter 1278mm Gen1 torsion bars but we do not know exactly when Mitsubishi switched over to these longer bars so always measure your existing torsion bars to confirm length prior to ordering. 

Bar Diameter: 26mm

Load Specs: HD Torsion Bars - Supports up to 220lbs of added constant weight

 


 
Installation Guides
*These links may contain independent information and are not a substitute for the Factory Service Manual procedure - use at your own risk. 
  • Note - The bars are side specific and are marked Left and Right accordingly, installing them on the wrong side will likely cause them to break. The front and rear spline counts are different so the bars can only fit in the correct way front to back.
  • Video 1
  • Video 2

Warranty Information

2 years / 25,000 miles

Reviews

(No reviews yet) Write a Review