|1992*-2000||Montero||Gen2||3.0L V6, 3.5L V6|
|1997-2004||Montero Sport||Gen1 & Gen2||2.4L L4, 3.0L V6, 3.5L V6|
Sold In Pairs
Lovells heavy duty Torsion Bars are available as an upgrade to enhance the load carrying ability of vehicles which have independent front ends (torsion bar front). Lovells torsion bars are manufactured from larger diameter bar than original equipment which will increase spring rate and maintain ride height when the vehicle is fitted with constant added weight over the front such as a steel bumper, winch, skids plates, etc. Lovells Torsion bars feature ‘upset’ forged ends which increase strength by improving the steel structure and rolled splines.
Length: 1308mm - Some early Gen2 Monteros use the shorter 1278mm Gen1 torsion bars but we do not know exactly when Mitsubishi switched over to these longer bars so always measure your existing torsion bars to confirm length prior to ordering.
Bar Diameter: 28mm
Load Specs: HD Torsion Bars - Supports up to 220lbs of added constant weight
- Note - The bars are side specific and are marked Left and Right accordingly, installing them on the wrong side will likely cause them to break. The front and rear spline counts are different so the bars can only fit in the correct way front to back.
- Video - "Torsion bar replacement on a Mitsubishi Pajero/Montero/Shogun."
- Video - "HOW TO: 4X4 TORSION BAR RE-INDEXING FRONT LIFT INDEX MITSUBISHI MONTERO PAJERO SHOGUN DELCIA L400."